Contrex M-Drive Manuale Utente Scaricare il pdf

M-DRIVE INSTALLATION/START-UP GUIDE

CAUTION

Hazardous Voltages. Can cause severe injury, death or damage to

equipment. The M-Drive should only be installed by a qualified

electrician.

Proper earth grounding of all electronic equipment is required for

successful operation. Connect a low impedance earth ground to

terminal 7 of connector J2.

Separate all logic and signal level wiring (J1, J3 and J4) from all

motor armature and AC power wiring (J2).

Shield all logic and signal wiring (J1, J3 and J4) and terminate to

earth ground at one point only.

REQUIRED WIRING

ONTREX, INC.ONTREX, INC.

ONTREX, INC.

SK1416 Rev 3SK1416 Rev 3

SK1416 Rev 3

Page 1

1 2 3 4

M-DRIVE INSTALLATION/START-UP GUIDECAUTIONHazardous Voltages. Can cause severe injury, death or damage toequipment. The M-Drive should only be instal

SCALINGAfter completing the required wiring of the M-Drive, follow the procedure below to scale the M-Drive for Masterformat RPM operation. Complete

FOLLOWER OPERATIONComplete the “Scaling” and “Tuning” procedures for Master mode (Page 2) before proceeding with Follower operation. To enable Follow

Step 4: Check MV-47 (Output).a) Should not be “0” or “100”.b) If “0”, then return to step 1 of “Scaling”.c) If “100”, check wiring to motor.Step 5

Nessun commento

Contrex M-Drive Manuale Utente